DeLonghi PAC C120E Owner Manual - Page 6

Semi-permanent installation - exhaust hose for

Get DeLonghi PAC C120E PDF manuals and user guides View all DeLonghi PAC C120E manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Semi-permanent installation SEMI-PERMANENT INSTALLATION If required, your appliance can also be installed semi-permanently (Fig. E). • Fit the wall flange (10) into the hole. • Fit the air exhaust hose (11) in the rele- vant housing located on the rear side of the appliance. (fig. A page 5). • Fit the end of the hose (11) to the wall flange (10) as shown in fig. G. G E Proceed as follows: • Drill a hole ø 5,25 inches (134 mm) in an outside wall or through a window pane. Respect the dimensions and height of the hole given in figure F and G. When the hose (11) is not connected, the drilled hole can be closed with the flange cap (10). NOTE: When installing the air conditioner semi-permanently, you should leave a door slightly open little as 1/2 " (1 cm) to guarantee correct ventilation and room pressure. in the window pane F in the wooden kickboard of a French window in the wall: you are recommended to insulate the section of wall using suitable insulation. "As special tools are required for installation, we suggest you have the appliance installed by specialized personnel." Keep the air hoses as short and free of curves as possible to avoid constrictions. 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
in the
window
pane
in the wall:
you are
recommended
to insulate the
section of wall
using suitable
insulation.
in the
wooden
kickboard
of a
French
window
F
Semi-permanent installation
SEMI-PERMANENT INSTALLATION
If required, your appliance can also be
installed semi-permanently (Fig.
E
).
Proceed as follows:
•
Drill a hole
ø 5,25 inches (134 mm) in an
outside wall or through a window pane.
Respect the
dimensions and height
of the
hole given in figure
F
and
G
.
•
Fit the wall flange (
10
) into the hole.
•
Fit the air exhaust hose
(
11
)
in the rele-
vant housing located on the rear side of
the appliance. (fig.
A
page 5).
•
Fit the end of the hose (
11
) to the wall
flange (
10
) as shown in fig.
G
.
When the hose (
11
) is not connected, the dril-
led
hole can be closed with the flange cap
(
10
).
NOTE:
When installing the air conditioner
semi-permanently, you should leave a door
slightly open
little as
1/2 “ (1 cm)
to guar-
antee correct ventilation and room pressure.
6
Keep the air hoses as short and free of
curves as possible to avoid constrictions.
“As special tools are required for installa-
tion, we suggest you have the applian-
ce installed by specialized personnel.”
E
G