Dell 1710n Service Manual - Page 213
Input sensor #1 removal, Remove the sensor assembly.
![]() |
View all Dell 1710n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
Input sensor #1 removal 1. Open the right side cover. 2. Disconnect the sensor cable at J9 on the controller card (front, near top of card). 3. Carefully place the printer on its top. 4. Using a small shank screwdriver, remove the screw (A) behind the ACM (autocompensator) pivot which holds the paper sensor in place. A 5. Remove the sensor assembly. 6. Reinstall the sensor so that the flag is spring loaded against the page as it advances in its path. 7. Verify the cable is captured and out of the paper path. Repair information 4-35
![](/manual_guide/products/dell-1710n-service-manual-37aaa5d/213.png)
Repair information
4-35
Input sensor #1 removal
1.
Open the right side cover.
2.
Disconnect the sensor cable at J9 on the controller card (front, near top
of card).
3.
Carefully place the printer on its top.
4.
Using a small shank screwdriver, remove the screw (A) behind the
ACM (autocompensator) pivot which holds the paper sensor in place.
5.
Remove the sensor assembly.
6.
Reinstall the sensor so that the flag is spring loaded against the page
as it advances in its path.
7.
Verify the cable is captured and out of the paper path.
A