Dell 1710n Service Manual - Page 234
Controller card connector pin values, Connector, Value, plugged, Comments
![]() |
View all Dell 1710n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 234 highlights
Controller card connector pin values (Also, see the wiring diagram at back of book.) These values were measured with all connections made (plugged) or with only one connector at a time unplugged to expose the pins. Always disconnect and connect with the printer power off. Otherwise, the values below may not match. Value Connector Pin # (plugged) J2 1, 4 +5 V dc 2 +24 V dc 6 Ground 3, 5 Signal J3 1, 3 +24 V dc 2, 4 +24 V dc J4 1, 2 0 V dc 3. 4 +5 V dc 5, 6 Signal 7 Ground 8, 9 +24 V dc 10 Signal 11 +5 12, 14 Ground 13 Signal J5 - - J6 - - J7 - - Value (unplugged) Comments +5 V dc +24 V dc Ground Signal +24 V dc 0 V dc Main power source to controller card Without tray 2 attached; Ready mode Manual and paper feed solenoids; Ready mode LVPS/HVPS; Ready mode - USB port - Network port (Ethernet) - Parallel port 5-4 Service Manual
![](/manual_guide/products/dell-1710n-service-manual-37aaa5d/234.png)