Dell Brocade 5100 Brocade Fabric OS v7.3.0a Release Notes v2.0 - Page 51

Closed with Code Change Defects in Fabric OS v7.3.0a Defect ID: DEFECT000500362 Technical Severity: Medium Probability: Medium Product: FOS Technology: Other Reported In Release: FOS7.3.0 Technology Area: Other Symptom: Customer may see QOS High/Low priority enabled ports default to Medium priority after hareboot on switches. Condition: The priority change will occur while processing sync dump, if Special Zones (Redirect or Traffic Isolation) are present in the database along with QOS Zone. Recovery: To recover the correct priority, execute the cfgsave and cfgenable commands. If the priority is not restored, execute the cfgdisable and cfgclear commands, and then re-create the same zone configuration and enable zone configuration. If both steps fail, reboot the switch to recover the correct priority. Defect ID: DEFECT000500567 Technical Severity: High Probability: Low Product: FOS Technology: Traffic Management Reported In Release: FOS7.3.0 Technology Area: Routing Symptom: Customer may see traffic disruption if ICL connections are not symmetric when 8G edge blade is present. Condition: When 8G edge port blade is present and ICL connections are not symmetric (which is a recommended use case). Workaround: Avoid configuring asymmetric ICL connections. Recovery: Reconfigure the ICL connection as symmetrical. Defect ID: DEFECT000509898 Technical Severity: Medium Probability: Medium Product: FOS Technology: Other Reported In Release: FOS7.3.0 Technology Area: Other Symptom: Switchshow and portcfgshow displays ports configuration as "Auto Negotiate" when configured as fixed speed after firmeare download to FOS 7.3.0 Condition: After a firmware download to FOS v7.3.0 from previous release, switchshow and portcfgshow displays port configuration as auto negotiate when configured as fixed speed. The actual link speed is the configured speed. Recovery: Perform a hareboot or hafailvoer after the firmware download to FOS v7.3.0. Defect ID: DEFECT000510334 Technical Severity: High Probability: Low Product: FOS Technology: Other Reported In Release: FOS7.0.2 Technology Area: Other Symptom: In an encryption environment (BES or FS8-18), the addition of a LUN to a crypto target container fails getting either device is busy or timeout when trying to configure. Condition: Issue can be seen when there are more ITLs configured in the LUN or encryption engine was stressed with heavy I/O. Defect ID: DEFECT000511719 Technical Severity: Medium Probability: Low Product: FOS Technology: Management Reported In Release: FOS7.3.0 Technology Area: Web Tools Symptom: Unable to view HA status of the 7840 FCIP tunnel from WebTools to determine if firmware download will be disruptive. Condition: WebTools does not display the HA status of a 7840 FCIP tunnel prior to firmware download Workaround: View the 7840 FCIP tunnel HA status from FOS CLI Fabric OS v7.3.0a Release Notes v2.0 Page 51 of 55