Dell Brocade 5100 Brocade Fabric OS v7.3.0a Release Notes v2.0 - Page 52
Defect ID, Technical Severity, Probability, Product, Technology, Reported In Release, Technology
View all Dell Brocade 5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Closed with Code Change Defects in Fabric OS v7.3.0a Defect ID: DEFECT000512057 Technical Severity: Medium Probability: High Product: FOS Technology: Monitoring/RAS Reported In Release: FOS7.2.0 Technology Area: Fabric Watch Symptom: Error messages start after firmware update from FOS v7.0.x to FOS v7.1.x and continue when upgrading to FOS v7.2.x. After downgrading back to 7.0.x, faulty port messages stop from Fabric Watch. Condition: Running FOS 7.1 and above, with a port remains in passive mode, which would simply complete speed negotiation and failing link init, results in FW-xxxx flood in RAS log. Workaround: Disable the port that does not cut off light Defect ID: DEFECT000512507 Technical Severity: High Probability: Medium Product: FOS Technology: Traffic Management Reported In Release: FOS7.2.0 Technology Area: Routing Symptom: Observed performance issue on FX8-24 when there are exactly two equal bandwidth FCIP tunnels. Condition: Only applicable when there are two incoming paths (E-ports, trunks, EX-ports) on a given FX8-24 or BR7800 ASIC Chip. Workaround: Use one or greater than two incoming path to FX8-24 and 7800, or configure one of the links with a slightly lower bandwidth. Defect ID: DEFECT000513923 Technical Severity: High Probability: High Product: FOS Technology: Virtualization Reported In Release: FOS7.2.0 Technology Area: Access Gateway Symptom: ELS commands get rejected and host on AG switch can no longer communicate with the target in the 3rd party vendor fabric. Condition: This may happen in a Fabric with Access Gateway F-port with at least one NPIV login, and one of the NPIV logins has a PID with the domain and area portion equal to that of the target. Workaround: Reconfigure the fabric switch so that the domain and area portions of PIDs on Access Gateway F- ports do not match the domain and area portions of the target's PID. Recovery: Reboot the Access Gateway switch. Defect ID: DEFECT000514203 Technical Severity: Medium Probability: Low Product: FOS Technology: Distance Reported In Release: FOS7.3.0 Technology Area: FCIP Symptom: The 7840 console output shows many XTUN 1997 messages during I/O. Condition: An active FCIP Tunnel on a lossy or busy network. Recovery: No impact to IO Defect ID: DEFECT000514741 Technical Severity: Medium Probability: High Product: FOS Technology: Distance Reported In Release: FOS7.3.0 Technology Area: FCIP Symptom: FFDC is observed for log drop message. The FFDC message is harmless in functionality, it is only for internal purpose to find out which message gets dropped. Condition: There could be many internal raslog messages that overrun the raslog queue, thus the message is seen Recovery: no action needed when this happens. Fabric OS v7.3.0a Release Notes v2.0 Page 52 of 55