Dell Brocade 6520 Fabric Watch Administrator's Guide Supporting Fabric OS v7.1 - Page 76
Port class guidelines and default settings
View all Dell Brocade 6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
7 Port class guidelines and default settings TABLE 15 Area Port class areas (Continued) Description Sync loss Packet loss (VE_Port only) Protocol errors (PE) Received packets (RXP) State changes (ST) (Port and VE_Port) Transmitted packets (TXP) Trunk utilization (E_Port, FCU_Port, and FOP_Port) Utilization (VE_Port only) Link reset The number of times a synchronization error occurs on the port. Two devices failed to communicate at the same speed. Synchronization errors are always accompanied by a link failure. Loss of synchronization errors frequently occur due to a faulty SFP or cable. The number of packets routed through a port exceeds the port bandwidth. The number of times a protocol error occurs on a port. Invalid state due to LRR on an online link. Occasionally these errors occur due to software glitches. Persistent errors occur due to hardware problems. The percentage of maximum bandwidth consumed in packet receipts. The state of the port has changed for one of the following reasons: • The port has gone offline. • The port has come online. • The port is faulty. The percentage of maximum bandwidth consumed in packet transmissions. The percent of utilization for the trunk at the time of the last poll. The percent of utilization for the trunk at the time of the last poll. The ports on which the number of link resets exceed the specified threshold value. NOTE Only the Packet loss, State changes, and Utilization areas are supported on the VE_Port. Port class guidelines and default settings There are different recommendations and default settings for the physical port, the E_Port, and the FOP_Port and FCU_Port. Refer to the following sections and plan carefully before you begin configuring the port: • "Physical port setting guidelines" • "E_Port subclass setting guidelines" • "FOP_Port and FCU_Port subclass setting guidelines" • "VE_Port class default settings" NOTE E_Ports and VE_Ports are not supported in Access Gateway mode. 56 Fabric Watch Administrator's Guide 53-1002752-01