Dell Brocade 815 Brocade Adapters Troubleshooting Guide - Page 145
Adapter BIOS and Event Message Reference, Adapter BIOS messages
View all Dell Brocade 815 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Adapter BIOS and Event Message Reference Appendix A This appendix provides details on BIOS messages that display during operation of option ROM and event messages that display during operation of adapter drivers. Included in these details are the message, cause, and action the user should perform after viewing these messages. Adapter BIOS messages Table 12 provides details on BIOS-related messages generated during operation of option ROM. The message, possible cause, and user action are provided. TABLE 12 Message Adapter BIOS messages Cause Recommended Action Adapter : No firmware present. Skipping card There is no boot firmware present on the card. Download the latest boot code file for installed Brocade adapters from your adapter's website. The boot code file is designated as: brocade_adapter_boot_fw_v where x.y.z is the version number. Adapter : Version mismatch: Card Ver. Disabling BIOS Current executing option ROM version is different from the one on the adapter. Update boot code on all the adapters in the system using instructions in the "Boot Code" chapter of the Brocade Adapters Installation and Reference Manual. Download the latest boot code file for installed Brocade adapters from your Brocade adapter's website. The boot code file is designated as: brocade_adapter_boot_fw_v where x.y.z is the version number. Adapter : No boot devices. Disabling BIOS BIOS on this adapter is enabled, however no boot devices are configured. Update boot code on all the adapters in the system using instructions in the "Boot Code" chapter of the Brocade Adapters Installation and Reference Manual. If booting from this adapter is not required, then ignore this message. If booting from this adapter is required, perform the following steps: 1 Check if boot devices are configured through the Brocade BIOS Configuration Utility. If not, configure devices and try booting again. 2 In the zoning information on the switch, verify if the target's WWN are in the same zone as that of initiator's WWN. Brocade Adapters Troubleshooting Guide 121 53-1002145-01