Home » Dell Manuals » Servers » Dell DX6004S » Manual Viewer

Dell DX6004S DX Cluster Services Node Installation and Configuration Guide - Page 10

Enter License Contact and Storage Information, Enter capacity keys one at a time

Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

After installation, a license shell is defaulted into the licensing interface. If published as is, this license will provide 0 TB of capacity for storing content. To correctly publish a license the following high-level steps are required: 1. Enter License Contact and Storage Information 2. Enter capacity keys one at a time 3. After all keys have been entered, publish the license Copyright © 2010 Caringo, Inc. All rights reserved 7 Version 2.0 December 2010

Section	Page
Cluster Services Node (CSN) Installation and Configuration Guide	1
Table of Contents	3
Chapter 1. Introduction to the DX Object Storage Cluster Services Node	4
1.1. DX Object Storage Cluster Services Node Overview	4
1.2. Components	4
1.3. About this Document	5
1.3.1. Audience	5
1.3.2. Scope	5
Chapter 2. Installation and Configuration	6
2.1. Requirements	6
2.1.1. Operating System	6
2.1.2. Network	6
2.2. Primary vs. Secondary	6
2.3. Installation Steps	7
2.3.1. Primary CSN Configuration	7
2.3.2. Secondary CSN Configuration	9
2.3.3. Configuring Object Storage Cluster Licensing	9
2.3.3.1. Contact and Storage Information	11
2.3.3.2. Entering License Keys	11
2.3.3.3. Publishing a License	12
2.3.3.4. Repurposing License Keys	12
2.4. Booting DX Storage Nodes	12
2.5. CSN Hardware Validation	13
2.6. Upgrading the CSN	13
2.6.1. Backup Compatibility Across Software Versions	14
2.7. CSN-Reset	14
Chapter 3. Running and Managing the CSN	15
3.1. Modifying CSN Network Configuration	15
3.1.1. Updating the Internal Interface	16
3.2. Modifying SNMP Access	17
3.3. Updating the DX Storage software version	17
3.4. Editing User Access	18
3.5. Configuration File Backup and Restore	19
3.5.1. Backup Manifest	20
3.5.2. Automatic Backups	21
3.5.3. Manual Backups	21
3.5.4. Restoring a Backup	21
3.5.5. Failover	21
3.5.5.1. Failover Without DX Storage	22
3.6. Configuring the SCSP Proxy	23
3.7. Syslog Configuration	25
3.8. Password Management	25
Chapter 4. Running and Managing DX Storage	26
4.1. Adding DX Storage Nodes	26
4.2. Updating Configuration Settings	26
4.3. DX Storage User Access	27
4.4. DX Storage Admin Console	28
4.5. Gathering SNMP Statistics	29
4.5.1. SNMP Command Examples	29
Chapter 5. Configuring and Managing DX Content Router	30
5.1. Configuring DX Content Router	30
5.1.1. Publisher	30
5.1.2. Replicator	31
5.2. Managing DX Content Router	33
5.2.1. Publisher Console	33
5.2.2. Gathering SNMP Statistics	33