Dell E1914H Dell User's Guide - Page 49
Self-Test - power save mode
View all Dell E1914H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Troubleshooting WARNING: Before you begin any of the procedures in this section, follow the Safety Instruction Self-Test Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly connected but the monitor screen remains dark, run the monitor self-test by performing the following steps: 1. Turn off both your computer and the monitor. 2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both Digital (white connector) and the Analog (blue connector) cables from the back of computer. 3. Turn on the monitor. The floating dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly. While in self-test mode, the power LED remains white. Also, depending upon the selected input, one of the dialogs shown below will continuously scroll through the screen. Dell E1914H / E2014H No VGA Cable The display will go into Power Save Mode in 5 minutes 4. This box also appears during normal system operation, if the video cable becomes disconnected or damaged. The monitor will enter Power Save Mode after 5 minutes if left at this state. 5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor. If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning properly. NOTE: Self-test feature check is not available for S-Video, Composite, and Component video modes. Troubleshooting 49