Dell External USB NTSC Contents: Dell External USB NTSC/ATSC TV Tuner User's G - Page 3

Software The Dell External USB NTSC/ATSC TV Tuner hardware ships with the following software: l Driver setup utility (DrvSetup.exe) l WDM driver (WaveATSC.sys, WaveATSC.inf, EzRating.dll) l Diagnostic utility (WaveDiag.exe, WaveDiag.cfg, WaveATSC.dev) The Dell External USB NTSC/ATSC Tuner is supported by Microsoft Windows XP Media Center Edition (MCE) - 2005 and Windows Vista release. Drivers use standard Microsoft DirectShow® property sets. The drivers can be found on the Dell Resource CD. An Install Shield is provided to make installation simple. Store the Resource CD that comes with your system in a safe place in case you need to reinstall the software. Platform Requirements l Microsoft Windows XP Media Center Edition 2005 l Minimum 256 MB RAM, 512 MB Recommended l 1.8 GHz Processor, 400 MHz Front Side Bus l DirectX® 9.1 or higher l Minimum three available USB type A ports: • two for the Dell External USB NTSC/ATSC TV Tuner (must be USB 2.0); • one for the Media Center remote control receiver; l 5400 RPM or faster disk drive Note: Disk DMA must be enabled for proper operation. Note: Connect the 2 USB A connectors into 2 adjacent (vertically stacked) connectors on the PC. Getting Help If you need additional help or require information that is not included in this guide, visit the Dell Support website support.dell.com or call 1-800-BUY-DELL Warranty Information See your Dell system warranty information for service and repair options available for your Dell External USB NTSC/ATSC TV Tuner product. Back to Contents Page