Dell Inspiron 1120 Contents: Mini PCI Type 3B Data Fax Modem by 3Com User's Gu - Page 4

X4 Y0 Y1 Y2 Y3 Y4 Z0 Z1 Z2 Z3 Z4 Z5 $ &$ &A0 &A1 &A2 &A3 &B0 &B1 &B2 &C0 &C1 &D0 &D1 &D2 &D3 &F0 &F1 &F2 &G0 &G1 &G2 &H0 &H1 &H2 ATX4 ATY0 ATY1 ATY2 ATY3 ATY4 ATZ0 ATZ1 ATZ2 ATZ3 ATZ4 ATZ5 AT$ AT&$ AT&A0 AT&A1 AT&A2 AT&A3 AT&B0 AT&B1 AT&B2 AT&C0 AT&C1 AT&D0 AT&D1 AT&D2 AT&D3 AT&F0 AT&F1 AT&F2 AT&G0 AT&G1 AT&G2 AT&H0 AT&H1 AT&H2 rate i.e., OK, CONNECT, RING, NO CARRIER, NO ANSWER, CONNECT XXXX, BUSY and ERROR Report all call progress result codes and connection rate X i.e., OK, CONNECT, RING, NO CARRIER, NO ANSWER, CONNECT XXXX, BUSY, NO DIAL TONE and ERROR On the next reset, use &W settings X On the next reset, use &W1 settings On the next reset, use &F settings On the next reset, use &F1 settings On the next reset, use &F2 settings Reset the modem according to the settings of ATY Reset the modem and use &W settings Reset the modem and use &W1 settings Reset the modem using &F settings and load factory default profile 1 Reset the modem using &F1 settings and load factory default profile Reset the modem using &F2 settings and load factory default profile 2 Display the list of AT commands Display the list of ampersand commands Disable data compression result codes Enable data compression result codes Enable modulation result codes Enable data compression result codes and add V.42bis X and MNP 5 protocol indicators Use a floating DTE speed X Use a fixed DTE speed Use a fixed DTE speed when using data compression Carrier detect is always on Carrier detect is controlled by the modem X Ignore DTR Use online command mode DTE controls DTR X DTE controls DTR and reset Set the factory profile that uses hardware (RTS/CTS) flow control (this is the active profile when the modem is shipped) Set the factory profile that uses hardware (RTS/CTS) flow control Set the factory profile that uses software (XON/XOFF) flow control No guard tone X Use 550 Hz guard tone Use 1800 Hz guard tone Flow control for transmitted data - Disable flow control Flow control for transmitted data - Enable hardware flow X control (RTS/CTS) Flow control for transmitted data - Enable software (XON/XOFF)