Dell Inspiron 13 5330 Service Manual - Page 36

Replace the four screws M1.6x2 that secure the touchpad bracket to the palm-rest and keyboard assembly.

Get Dell Inspiron 13 5330 PDF manuals and user guides View all Dell Inspiron 13 5330 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

Steps 1. Align and place the touchpad into the slot on the palm-rest and keyboard assembly. 2. Flip the computer over and open the display to ensure that the touchpad is equally aligned on all sides. NOTE: The image below shows the proper touchpad alignment for your computer. 3. Close the display and flip the computer over. 4. Replace the two screws (M2x1.8) that secure the touchpad to the palm-rest and keyboard assembly. 5. Align the screw holes on the touchpad bracket with the screw holes on the palm-rest and keyboard assembly. 6. Replace the four screws (M1.6x2) that secure the touchpad bracket to the palm-rest and keyboard assembly. 7. Slide the touchpad cable into the connector on the system board and close the latch to secure the cable. Next steps 1. Install the speakers. 2. Install the battery. 3. Install the base cover. 4. Follow the procedure in After working inside your computer. 36 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
Steps
1.
Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
2.
Flip the computer over and open the display to ensure that the touchpad is equally aligned on all sides.
NOTE:
The image below shows the proper touchpad alignment for your computer.
3.
Close the display and flip the computer over.
4.
Replace the two screws (M2x1.8) that secure the touchpad to the palm-rest and keyboard assembly.
5.
Align the screw holes on the touchpad bracket with the screw holes on the palm-rest and keyboard assembly.
6.
Replace the four screws (M1.6x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
7.
Slide the touchpad cable into the connector on the system board and close the latch to secure the cable.
Next steps
1.
Install the
speakers
.
2.
Install the
battery
.
3.
Install the
base cover
.
4.
Follow the procedure in
After working inside your computer
.
36
Removing and installing components