Dell Inspiron 13 5330 Service Manual - Page 45

Installing the heat sink, Power button, Removing the power button

Get Dell Inspiron 13 5330 PDF manuals and user guides View all Dell Inspiron 13 5330 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

Installing the heat sink Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task NOTE: If either the system board or the fan and heat-sink assembly is replaced, use the thermal pad that is provided in the kit to ensure that thermal conductivity is achieved. CAUTION: Incorrect alignment of the heat sink can damage the system board and processor. The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure. Steps 1. Align and place the heat sink on the system board. 2. In sequential order (1>2>3>4), tighten the four captive screws (M2x6) that secure the heat sink to the system board. 3. Adhere the tape that secures the display-cable connector latch to the system board. Next steps 1. Install the base cover. 2. Follow the procedure in After working inside your computer. Power button Removing the power button Prerequisites 1. Follow the procedure in Before working inside your computer. Removing and installing components 45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
Installing the heat sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
If either the system board or the fan and heat-sink assembly is replaced, use the thermal pad that is provided in the
kit to ensure that thermal conductivity is achieved.
CAUTION:
Incorrect alignment of the heat sink can damage the system board and processor.
The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure.
Steps
1.
Align and place the heat sink on the system board.
2.
In sequential order (1>2>3>4), tighten the four captive screws (M2x6) that secure the heat sink to the system board.
3.
Adhere the tape that secures the display-cable connector latch to the system board.
Next steps
1.
Install the
base cover
.
2.
Follow the procedure in
After working inside your computer
.
Power button
Removing the power button
Prerequisites
1.
Follow the procedure in
Before working inside your computer
.
Removing and installing components
45