Dell Latitude 7400 2-in-1 Service Manual - Page 65
Installing the display assembly
View all Dell Latitude 7400 2-in-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
NOTE: The display assembly for the Latitude 7400 2-in-1 is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is removed from the bottom chassis. If any components of the HUD assembly are malfunctioning and need to be replaced, replace the entire display assembly. Installing the display assembly Steps 1. Install the display assembly with hinges open at 180º aligned to the computer [1]. 2. Replace the six (M2.5x3.5) screws [1] that secures the display hinges to the computer [2]. 3. Connect the display cable [1] to the connector on the system board. 4. Close the latch [2] and adhere the tape on the display cable [3]. Removing and installing components 65
NOTE:
The display assembly for the Latitude 7400 2-in-1 is a Hinge-Up Design (HUD) assembly and cannot be further
disassembled once it is removed from the bottom chassis. If any components of the HUD assembly are malfunctioning
and need to be replaced, replace the entire display assembly.
Installing the display assembly
Steps
1.
Install the display assembly with hinges open at 180ยบ aligned to the computer [1].
2.
Replace the six (M2.5x3.5) screws [1] that secures the display hinges to the computer [2].
3.
Connect the display cable [1] to the connector on the system board.
4.
Close the latch [2] and adhere the tape on the display cable [3].
Removing and installing components
65