Dell Latitude CPt S Service Manual - Page 46

6. Remove the left module latch button from the bottom case assembly by carefully squeezing the snap tabs (see Figure 25). Apply pressure to the module latch and spring while unsnapping the snap tabs to prevent the module latch assembly from coming loose from the case. If the module latch assembly does come loose from the case: a. Carefully reinsert the spring onto the slider on the module latch, and reinstall the module latch into the holding features on the inside of the case. b. Ensure that the slider is inserted in its respective hole, that the side of the latch with the two bumps is facing the back of the case, and that the surface with the wear ribs is facing the bottom of the case (see Figure 25). 7. Snap in the new latch button from the bottom of the base, making certain its snap tabs are fully engaged in the module latch. 8. Ensure that the newly installed latch moves smoothly and freely when pushed and released. 9. Repeat steps 6 through 8 for the latch on the right side. bumps (2) wear ribs (2) 38 Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual