Dell OptiPlex 330 Quick Reference - Page 53

Beep Codes Your computer might emit a series of beeps during start-up if the monitor cannot display errors or problems. This series of beeps, called a beep code, identifies a problem. For example, beep code 1-3-1 (one possible beep code) consists of one beep, a burst of three beeps, and then one beep. This beep code tells you that the computer encountered a memory problem. Reseating the memory modules may correct the following beep code errors. If the problem persists, contact Dell (see "Contacting Dell" in the User's Guide) for instructions on obtaining technical assistance. Code 1-3-1 through 2-4-4 4-3-1 Cause Memory not being properly identified or used Memory failure above address 0FFFFh If you experience any of the following beep code errors, see "Contacting Dell" in the User's Guide for instructions on obtaining technical assistance. Code 1-1-2 1-1-3 1-1-4 1-2-1 1-2-2 1-2-3 1-3 1-3-1 through 2-4-4 3-1-1 3-1-2 3-1-3 3-1-4 Cause Microprocessor register failure NVRAM read/write failure ROM BIOS checksum failure Programmable interval timer failure DMA initialization failure DMA page register read/write failure Video Memory Test failure Memory not being properly identified or used Slave DMA register failure Master DMA register failure Master interrupt mask register failure Slave interrupt mask register failure Quick Reference Guide 53