Dell OptiPlex 760 Service Manual - Page 164

Steady Green A possible graphics card failure has occurred. l If available, install working memory of the same type into your computer (see Memory). l If the problem persists, contact Dell (see Contacting Dell). l Reseat any installed graphics cards (see the "Cards" section for your computer). l If available, install a working graphics card into your computer. l If the problem persists, contact Dell (see Contacting Dell). Steady Green A possible floppy drive or hard drive Reseat all power and data cables. failure has occurred. Steady Green A possible USB failure has occurred. Reinstall all USB devices and check all cable connections. Steady Green Steady Green Steady Green Steady Green Steady Green No memory modules are detected. Memory modules are detected, but a memory configuration or compatibility error has occurred. l If two or more memory modules are installed, remove the modules (see Removing Memory Module (s)), then reinstall one module (see Installing Memory Module (s)) and restart the computer. If the computer starts normally, continue to install additional memory modules (one at a time) until you have identified a faulty module or reinstalled all modules without error. l If available, install working memory of the same type into your computer (see Memory). l If the problem persists, contact Dell (see Contacting Dell). l Ensure that no special requirements for memory module/connector placement exist. l Ensure that the memory you are using is supported by your computer (see the Setup and Quick Reference Guide that ships with your computer). l If the problem persists, contact Dell (see Contacting Dell). A possible expansion card failure has occurred. l Determine if a conflict exists by removing an expansion card (not a graphics card) and restarting the computer (see the "Cards" section for your computer). l If the problem persists, reinstall the card you removed, then remove a different card and restart the computer. l Repeat this process for each expansion card installed. If the computer starts normally, troubleshoot the last card removed from the computer for resource conflicts. l If the problem persists, contact Dell (see Contacting Dell). Another failure has occurred. l Ensure that all hard drive and optical drive cables are properly connected to the system board (see the "System Board Components" section for your computer). l If there is an error message on the screen identifying a problem with a device (such as the floppy drive or hard drive), check the device to make sure it is functioning properly. l If the operating system is attempting to boot from a device (such as the floppy drive or optical drive), check system setup to ensure the boot sequence is correct for the devices installed on your computer. l If the problem persists, contact Dell (see Contacting Dell). The computer is in standby mode. Press a key on the keyboard, move the mouse, or press the power button to resume normal operation. Blinking Green Power Supply Diagnostic Light The power supply diagnostic light located on the back of the computer, near the power connector. The light remains solid or off to indicate different states: l No light - Indicates no power available for the power supply or the power supply is not working. l Green light - Indicates power availability for the power supply.