Dell PowerConnect 5224 User Manual - Page 20

Switch 3248: Re-Enabling a Shutdown Port, disabled. To re-enable a shutdown port, follow these steps - cli

Get Dell PowerConnect 5224 PDF manuals and user guides View all Dell PowerConnect 5224 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

www.dell.com | support.dell.com The following figure is representative of PowerConnect 3248. NOTE: To re-enable a port using the CLI, use the no shutdown command in Interface Configuration mode. Switch 3248: Re-Enabling a Shutdown Port If security is enabled on a port and the intrusion action set to Shutdown or Trap and Shutdown, then a security violation will cause the port to be disabled. To re-enable a shutdown port, follow these steps: 1 Click the Ports/Port Configuration page. 2 For the port that is disabled, click the check box in the Admin/Oper column. 3 Click Apply Changes to enable the port. Switch 3248: CLI Commands The following table summarizes the equivalent CLI commands for items in the Ports/Port Security page. Command port security [action {shutdown | trap | trapand-shutdown}] Usage Enables and configures port security on a port. The no form command resets the values to the defaults. 20 Addendum to the 32 48 and 5 224 User 's Guides

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
20
Addendum to the 3248 and 5224 User’s Guides
www.dell.com | support.dell.com
The following figure is representative of PowerConnect 3248.
Switch 3248: Re-Enabling a Shutdown Port
If security is enabled on a port and the intrusion action set to
Shutdown
or
Trap and Shutdown
, then a security violation will cause the port to be
disabled. To re-enable a shutdown port, follow these steps:
NOTE:
To re-enable a
port using the CLI, use
the
no shutdown
command in Interface
Configuration mode.
1
Click the
Ports/Port Configuration
page.
2
For the port that is disabled, click the check box in the
Admin/Oper
column.
3
Click
Apply Changes
to enable the port.
Switch 3248: CLI Commands
The following table summarizes the equivalent CLI commands for items in
the
Ports/Port Security
page.
Command
Usage
port security [action
{shutdown | trap | trap-
and-shutdown}]
Enables and configures port security on a port.
The
no
form command resets the values to the
defaults.