Dell PowerConnect 5324 Release Notes - Page 10

PowerConnect 5324 Release Notes Documentation updates Introduction This document lists the changes from the PowerConnect 5324 User's Guide. The modifications are due to instances discovered in various user environments. General The following must be changed globally: Starting and Configuring the Device Assigning Static IP Addresses on an Inband Interface Modify the following: Current Console (config-if) # ip address 192.168.1.123/24 255.255.255.0 New Console (config-if) # ip address 192.168.1.123 255.255.255.0 Configuring an Initial HTTPS Password Delete the following: Enter the following commands once when configuring to use a terminal, a Telnet, or an SSH session in order to use an HTTPS session. Note: In the Web browser enable SSL 2.0 or greater for the page content to be displayed. console(config)# crypto certificate generate key_generate console(config)# ip https server ƒ Telnet Connection To start communications using automatic baud detection, press the Enter key twice. The factory default is autobaud enabled and no synchronization between a terminal and a device is required during the initial device installation. If, during the operation, the terminal was replaced by another one or the speed mode was switched over on the device, the following must be taken into consideration: • A blank screen appearing after reset is an indication that the terminal and the device are not synchronized. To activate the autobaud option, press the Enter key twice. • If the autobaud option is enabled on the device, it automatically becomes operational after reset ONLY ONCE, after pressing the Enter key twice. ƒ Configuring Domain Name Systems Under the Add DNS page add the following field description: DNS Server - DNS Server Name. The name cannot start with a numeric character. System Firmware Version 2.0.0.39 Subject to Change Without Notice Page 6