Dell PowerConnect 6248P Getting Started Guide - Page 160

www.dell.com | support.dell.com Enter Dell Easy Setup Wizard POST Welcome to Dell Easy Setup Wizard The setup wizard guides you through the initial switch configuration, and gets you up and running as quickly as possible.You can skip the setup wizard, and enter CLI mode to manually configure the switch.You must respond to the next question to run the setup wizard within 60 seconds, otherwise the system will continue with normal operation using the default system configuration.Note: You can exit the setup wizard at any point by entering [ctrl+z]. Would you like to run the setup wizard (you must answer this question within 60 seconds)? [Y/N] y 手順 1： The system is not configured for SNMP management by default.To manage the switch using SNMP (required for Dell Open Manage Network Manager) you can: o Set up the initial SNMP version 1 & 2 now. o Return later and set up other SNMP accounts.(For more information on setting up an SNMP version 3 account, see the user documentation). Would you like to configure the SNMP management interface now?[Y/N] y To configure the SNMP management account you must specify the management system IP address and the "community string" or password that the particular management system uses to access the switch.The wizard automatically assigns the highest access level [Privilege Level 15] to this account.You can use Dell Open Manage Network Manager or other management interfaces to change this setting and to add additional management systems later.For more information on adding management systems, see the User's Guide. 158 はじめに