Dell PowerConnect 8024F User's Guide - Page 244

Configuring OSPFv3 Traps Using CLI Commands For information about the CLI command that performs this function, see the SNMP Commands chapter in the CLI Reference Guide. The following table shows the equivalent CLI command you use to configure OSPFv3 traps. Table 6-56. OSPFv3 Trap Command CLI Command snmp-server enable traps ospfv3 Description Enables OSPFv3 traps. Trap Log The Trap Log page is used to view entries that have been written to the trap log. To access the Trap Log page, click System →Trap Manager →Trap Log in the navigation tree. Figure 6-115. Trap Logs The Trap Log page contains the following fields: • Number of Traps Since Last Reset - The number of traps generated since the trap log entries were last cleared. • Trap Log Capacity - The maximum number of traps stored in the log. If the number of traps exceeds the capacity, the entries will overwrite the oldest entries. • Number of Traps Since Log Last Viewed - The number of traps that have occurred since the traps were last displayed. Displaying the traps by any method (terminal interface display, Web display etc.) will cause this counter to be cleared to 0. 244 Configuring System Information