Dell PowerConnect B-RX BigIron RX Series Configuration Guide v02.7.03 - Page 145

Setting passwords 4 To set the password "letmein" for Telnet access to the CLI, enter the following command at the global CONFIG level. BigIron RX(config)# enable telnet password letmein Syntax: [no] enable telnet password Suppressing Telnet connection rejection messages By default, if a device denies Telnet management access to the device, the software sends a message to the denied Telnet client. You can optionally suppress the rejection message. When you enable the option, a denied Telnet client does not receive a message from the device. Instead, the denied client simply does not gain access. To suppress the connection rejection message sent by the device to a denied Telnet client, enter the following command at the global CONFIG level of the CLI. BigIron RX(config)# telnet server suppress-reject-message Syntax: [no] telnet server suppress-reject-message Setting passwords for management privilege levels You can set one password for each of the following management privilege levels: • Super User level - Allows complete read-and-write access to the system. This is generally for system administrators and is the only management privilege level that allows you to configure passwords. • Port Configuration level - Allows read-and-write access for specific ports but not for global (system-wide) parameters. • Read Only level - Allows access to the Privileged EXEC mode and CONFIG mode of the CLI but only with read access. You can assign a password to each management privilege level. You also can configure up to 16 user accounts consisting of a user name and password, and assign each user account to one of the three privilege levels. Refer to "Setting up local user accounts" on page 76. NOTE You must use the CLI to assign a password for management privilege levels. You cannot assign a password using the Web Management Interface. If you configure user accounts in addition to privilege level passwords, the device will validate a user's access attempt using one or both methods (local user account or privilege level password), depending on the order you specify in the authentication-method lists. Refer to "Configuring authentication-method lists" on page 113. Follow the steps to set passwords for management privilege levels. 1. At the opening CLI prompt, enter the following command to change to the Privileged level of the EXEC mode. BigIron RX> enable BigIron RX# 2. Access the CONFIG level of the CLI by entering the following command. BigIron RX# configure terminal BigIron RX(config)# BigIron RX Series Configuration Guide 73 53-1001986-01