Dell PowerConnect M6348 Command Line Interface Guide - Page 181

Command Mode Interface Configuration (Ethernet, Port-channel) mode User Guidelines When port security is enabled on an interface, all dynamic entries learned up to that point are flushed, and new entries can be learned only to the limit set by the port security max command. The default limit is 100 dynamic MAC addresses. Example In this example, frame forwarding is enabled without learning, and with traps sent every 100 seconds on port g1. console(config)#interface ethernet 1/g1 console(config-if-1/g1)#port security forward trap 100 port security max Use the port security max command in Interface Configuration mode to configure the maximum addresses that can be learned on the port while the port is in port security mode. To return to the system default, use the no form of this command. Syntax port security max max-addr no port security max • max-addr - The maximum number of addresses that can be learning on the port. (Range: 0- 100) Default Configuration The default value for this command is 100. Command Mode Interface Configuration (Ethernet, Port-channel) mode User Guidelines This command has no user guidelines. Example The following example shows using this command in Ethernet Interface Configuration mode. console(config-if-1/g3)# port security max 80 181