Dell PowerConnect M6348 Command Line Interface Guide - Page 287

ip igmp snooping querier election participate This command enables the Snooping Querier to participate in the Querier Election process when it discovers the presence of another Querier in the VLAN. When this mode is enabled, if the Snooping Querier finds that the other Querier source address is more than the Snooping Querier address, it stops sending periodic queries. If the Snooping Querier wins the election, then it continues sending periodic queries. The no form of this command sets the snooping querier not to participate in the querier election but to go into a non-querier mode as soon in as it discovers the presence of another querier in the same VLAN. Syntax ip igmp snooping querier election participate vlan-id no ip igmp snooping querier election participate vlan-id Default Configuration The snooping querier is configured to not participate in the querier election by default. Command Mode VLAN Configuration mode User Guidelines This command has no user guidelines. Example The following example configures the snooping querier to participate in the querier election. console(config-vlan)#ip igmp snooping querier election participate ip igmp snooping querier query-interval This command sets the IGMP Querier Query Interval time, which is the amount of time in seconds that the switch waits before sending another periodic query. The no form of this command sets the IGMP Querier Query Interval time to its default value. Syntax ip igmp snooping querier query-interval seconds no ip igmp snooping querier query-interval • seconds - Amount of time in seconds that the switch waits before sending another general query. (Range: 1-1800) 287