Dell PowerEdge 1750 Information Update (.pdf) - Page 6
Disconnect the CD drive interface cable from the CD_ROM connector on - hard drives
View all Dell PowerEdge 1750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
www.dell.com | support.dell.com Figure 1-1. Opening the System Covers left cover optional security screw latch right cover 6 Remove the SCSI backplane board: a Pull each hard-drive carrier partially out of its slot, approximately 2.5 cm (1 inch). b Disconnect the diskette-drive interface cable from the FLOPPY connector on the backplane board. See Figure 1-2. c Disconnect the CD drive interface cable from the CD_ROM connector on the backplane board. See Figure 1-2. d Press the release latch in toward the backplane board and use the handle to pull the board out of its connector and up out of the chassis. See Figure 1-2. 1-2 Installing or Replacing an ERA/O Card
1-2
Installing or Replacing an ERA/O Card
www.dell.com | support.dell.com
Figure 1-1.
Opening the System Covers
6
Remove the SCSI backplane board:
a
Pull each hard-drive carrier partially out of its slot, approximately 2.5 cm (1 inch).
b
Disconnect the diskette-drive interface cable from the FLOPPY connector on the
backplane board. See Figure 1-2.
c
Disconnect the CD drive interface cable from the CD_ROM connector on the
backplane board. See Figure 1-2.
d
Press the release latch in toward the backplane board and use the handle to pull
the board out of its connector and up out of the chassis. See Figure 1-2.
latch
optional security screw
right cover
left cover