Dell PowerEdge 2100 Service Manual - Page 60
System Power Supply
View all Dell PowerEdge 2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
System Power Supply power supply power-supply mounting screws (4) AC power connector Figure 4-10. Power Supply Removal To remove the system power supply, follow these steps: 1. Disconnect the AC power cable from the AC power connector on the back of the power supply. 2. Disconnect the DC power cables from the system board (see Figure 4-12), the externally accessible drives, and the hard-disk drives (see Figure 4-5). Be sure to record the connector number and plug location for each power cable. 3. Remove the four power-supply mounting screws. 4. Slide the power supply forward about an inch to clear the retaining tabs, then lift it out of the computer. When you reinstall the power supply, be sure the slots on the bottom of the power supply engage the retaining tabs on the computer chassis. 4-12 Dell PowerEdge 2100/180 and 2100/200 Systems Service Manual