Dell PowerEdge 2400 Installing Redundant Power Supplies - Page 5
Dell PowerEdge 2400 Systems, Installing Redundant Power Supplies, Power-supply, mounting, screws 2,
 |
View all Dell PowerEdge 2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Power supply Power-supply mounting screws (2) 7. Slide the power supply out of the system chassis. 8. Install the PSDB onto the PSDB tray (see Figure 1-3): a. While holding the PSDB by its edges, position the PSDB so that the three tabs on the PSDB tray fit through the corresponding slots in the PSDB and the two power supply connectors face the back of the chassis. b. Slide the PSDB toward the back of the system about 1 cm (a quarter of an inch). c. Secure the PSDB by tightening the thumbscrew. Dell PowerEdge 2400 Systems - Installing Redundant Power Supplies 1-3
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Dell PowerEdge 2400 Systems
—
Installing Redundant Power Supplies
1-3
±²³´µ¶·¸¹Åº··»¶¼½¾²¿³·ÀÁ¶·Æ½Ç¶µ·È´ÃÃÉÊ
7.
Slide the power supply out of the system chassis.
8.
Install the PSDB onto the PSDB tray (see Figure 1-3):
a.
While holding the PSDB by its edges, position the PSDB so that the three
tabs on the PSDB tray fit through the corresponding slots in the PSDB and
the two power supply connectors face the back of the chassis.
b.
Slide the PSDB toward the back of the system about 1 cm (a quarter of an
inch).
c.
Secure the PSDB by tightening the thumbscrew.
Power-supply
mounting
screws (2)
Power
supply