Dell PowerEdge 6850 Installation and Troubleshooting Guide (.htm) - Page 17
Installing the VersaRails Slide Assemblies
View all Dell PowerEdge 6850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installing the VersaRails Slide Assemblies 1 At the front of the rack cabinet, place a VersaRails slide assembly so that its mounting-bracket flange fits between the marks or tape (or numbered location) on the rack (see Figure 1-6). The holes on the front of the mounting bracket should align with the holes between the marks on the front vertical rail. 2 Install a 10-32 x 0.5-inch flange-head Phillips screws in the mounting flange's top hole and the bottom hole (see Figure 1-6). 3 At the back of the cabinet, pull back on the mounting-bracket flange until the mounting holes align with their respective holes on the back vertical rail. 4 Install 10-32 x 0.5-inch flange-head Phillips screws in the second and third holes (middle holes) of the back mounting flange to secure the slide assembly to the back vertical rail. NOTE: The top and bottom flange holes will be used later for installing the cable-management arm retainer. 5 Repeat steps 1 through 4 for the slide assembly on the other side of the rack. NOTE: Ensure that the rails are mounted at the same vertical position on both sides of the rack. Dell™ Rack Installation Guide 15