Dell PowerEdge C6420 EMC Technical Specifications 1 - Page 18

Maximum vibration specifications, Fresh Air Operation, Fresh Air operation restrictions

Page 18 highlights

Table 19. Gaseous contamination specifications Gaseous contamination Copper coupon corrosion rate Specifications

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23

Table 19. Gaseous contamination specifications
Gaseous contamination
Specifications
Copper coupon corrosion rate
<300 Å/month per Class G1 as defined by ANSI/ISA71.04-2013
Silver coupon corrosion rate
<200 Å/month per Class G1 as defined by ANSI/ISA71.04-2013
NOTE:
Maximum corrosive contaminant levels measured at ≤50% relative humidity.
Maximum vibration specifications
Table 20. Maximum vibration specifications
Maximum vibration
Specifications
Operating
0.26 Grms at 5 Hz to 350 Hz (all operation orientations).
Storage
1.88 Grms at 10 Hz to 500 Hz for 15 min (all six sides tested).
Maximum shock specifications
Table 21. Maximum shock specifications
Maximum shock
Specifications
Operating
24 executed shock pulses 6 G in the positive and negative x, y, z
axis for up to 11 ms (four pulses on each side of the system).
Storage
Six consecutively executed shock pulses of 71 G in the positive and
negative x, y, z axes for up to 2 ms (one pulse on each side of the
system).
Maximum altitude specifications
Table 22. Maximum altitude specifications
Maximum altitude
Specifications
Operating
3048 m (10,000 ft)
Storage
12,000 m (39,370 ft)
Fresh Air Operation
Fresh Air operation restrictions
Processors with a TDP greater than 105 W are not supported
Support for processors of 85 W and below without PERC restrictions
3.5-inch drive configuration is not supported
114-mm heat sink is required for the processor in CPU1 socket
Kerby-flat OCP is not supported
M.2 card on DCS Mezzanine slot is not supported.
NVMe SSD is not supported
AEP DIMM and LRDIMM are not supported
PCIe cards greater than 25 W are not supported
H730 PERC and H330 support for 105-W processors
18
Technical specifications