Dell PowerEdge M520 Dell FC8PT Pass-Through Module Quick Start Guide and User - Page 5
Install the Pass-Through Module
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1. Install the Pass-Through Module NOTE: Computer equipment contains static-sensitive components that may be damaged during handling. Static precautions such as grounded wrist straps are recommended during the installation process. 1 Remove the pin cover from the connector pins at the back of the passthrough module, as shown in Figure 1-1, Removing the Pin Cover. Figure 1-1. Removing the Pin Cover 2 Locate an empty module bay in the server. 3 If the selected bay contains an I/O module blank, remove it. 4 Make sure that the latching arm is in the unlatched position, and slide the pass-through module into the bay until it stops. FC8PT Pass-Through Module 5
FC8PT Pass-Through Module
5
1. Install the Pass-Through Module
NOTE:
Computer equipment contains static-sensitive components that may be
damaged during handling. Static precautions such as grounded wrist straps are
recommended during the installation process.
1
Remove the pin cover from the connector pins at the back of the pass-
through module, as shown in Figure 1-1, Removing the Pin Cover.
Figure 1-1.
Removing the Pin Cover
2
Locate an empty module bay in the server.
3
If the selected bay contains an I/O module blank, remove it.
4
Make sure that the latching arm is in the unlatched position, and slide the
pass-through module into the bay until it stops.