Dell PowerEdge M520 Dell FC8PT Pass-Through Module Quick Start Guide and User - Page 6
Attach a Fiber Optic Cable (Optional
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Figure 1-2. Installing the Pass-Through Module 5 Rotate the latching arm upward until it is flush against the front panel, and the top of the arm is seated in the latch, as shown in Figure 1-2, Installing the Pass-Through Module. 2. Attach a Fiber Optic Cable (Optional) Install a fiber optic cable between the pass-through module and the target device. With short-wave lasers, use multimode fiber optic cable that adheres to the following specifications. Fiber Optic Cable Maximum Length Minimum Connector Length 62.5/125 μm (multimode) 200 150 meters at 2.125 Gb/s .5 meters LC MHz*km bandwidth cable 70 meters at 4.25 Gb/s 21 meters at 8.5 Gb/s 6 FC8PT Pass-Through Module
6
FC8PT Pass-Through Module
Figure 1-2.
Installing the Pass-Through Module
5
Rotate the latching arm upward until it is flush against the front panel,
and the top of the arm is seated in the latch, as shown in Figure 1-2,
Installing the Pass-Through Module.
2. Attach a Fiber Optic Cable
(Optional)
Install a fiber optic cable between the pass-through module and the target
device. With short-wave lasers, use multimode fiber optic cable that adheres
to the following specifications.
Fiber Optic Cable
Maximum Length
Minimum
Length
Connector
62.5/125
μ
m (multimode) 200
MHz*km bandwidth cable
150 meters at 2.125 Gb/s
70 meters at 4.25 Gb/s
21 meters at 8.5 Gb/s
.5 meters
LC