Dell PowerEdge M520 Dell 10 Gb Ethernet Pass Through-k  for M1000e So - Page 12

Rev 1.00 3 Command Line Interface (CLI) Reference Software User's Manual 10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described in this section after successfully connecting to the 10GbE PTM CLI according to the procedure described in Section 2, "Connecting to the 10GbE PTM CLI," on page 8. 3.1 Quick Reference Table 5 provides a quick reference to the CLI commands: Table 5 - List of Commands Command name Short Description Reference General Commands help Shows the list of available commands exit Exit current privilege level Section 3.3.1, "help," on page 13 Section 3.3.2, "exit," on page 13 Software Image Commands show image ver Shows the software image version copy image from- Upload new software image to the PTM file Section 3.4.1, "show image ver," on page 13 Section 3.4.2, "copy image from-file," on page 14 Port Commands show port link Shows port link state show port module Shows uplink module parameters Section 3.5.1, "show port link," on page 15 Section 3.5.2, "show port module," on page 16 3.2 CLI Command Reference Conventions This section describes the PTM CLI commands. For each command, the following information is provided: • Synopsys: Lists the command name and any required or optional parameters. Variable parameters (like port numbers) are shown in italics. Optional parameters are shown in square brackets, e.g. [optional_parameter]. Required parameters are shown with no brackets. • Description: Provides a detailed description of the command and of all its parameters 12