Dell PowerEdge M520 Dell 10 Gb Ethernet Pass Through-k  for M1000e So - Page 15

Rev 1.00 3.5 Port Commands 3.5.1 show port link Synopsys: show port link [port_number] Description: This command displays detailed port information. If an uplink port number is specified ([port_number]), then the command displays information only for this port; otherwise, the command displays information for all the ports. The command displays the following information per port: • Port number • Port group identifier and speed: A, B, followed by the configured speed (10G) • Pass through connection status, may have one of the following values: down - either uplink or downlink is not connected mismatch - both uplink and downlink are connected, but there is a mismatch 10G - uplink and downlink are connected at 10GbE • Downlink port link state: - down: blade not present - 10G: 10GbE link • Uplink port link state: - empty: No module present - module_type [no link]: Module is present (module type is shown); no link: optical fiber cable is disconnected Example: # show port link Port Group Connect Downlink Uplink Status 1 A (10G) 10G 10G SFP+ SR Link Up 2 A (10G) 10G 10G SFP+ SR Link Up 3 A (10G) 10G 10G SFP+ LR Link Up 4 A (10G) 10G 10G SFP+ SR Link Up 5 A (10G) 10G 10G SFP+ SR Link Up 6 A (10G) mismatch 10G SFP SX Link Down 7 A (10G) down down SFP+ SR Link Down 8 A (10G) down down empty 9 B (10G) mismatch 10G SFP SX Link Down 10 B (10G) mismatch 10G SFP SX Link Down 11 B (10G) mismatch 10G SFP SX Link Down 12 B (10G) mismatch 10G SFP LX Link Down 13 B (10G) down down empty 14 B (10G) down 10G SFP+ SR Link Down 15 B (10G) mismatch 1G SFP+ SR Link Down 16 B (10G) mismatch 1G SFP+ SR Link Down 15