Dell PowerEdge M710 Hardware Owner's Manual - Page 335
System and Setup, Password Features
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 335 highlights
6 Close the blade. See "Closing the Blade" on page 159. 7 Install the blade. See "Installing a Blade" on page 148. When the blade is on, the power-on indicator is solid green. Allow the blade to finish booting. The existing passwords are not disabled (erased) until the system boots with the password removed. However, before you assign a new system and/or setup password, you must reinstall the password jumper. NOTE: If you assign a new system and/or setup password with the jumper removed, the system disables the new password(s) the next time it boots. 8 Remove the blade. See "Removing a Blade" on page 145. 9 Open the blade. See "Opening the Blade" on page 149. 10 If you are restoring the jumper setting on a PowerEdge M905 or M805 blade, remove the system board to gain access to the jumpers. See "Removing the System Board" on page 255. 11 Relocate the jumper plug to enable the password feature. 12 If you are restoring the jumper setting on a PowerEdge M905 or M805 blade, reinstall the system board. See "Installing the System Board" on page 258. 13 Close the blade. See "Closing the Blade" on page 159. 14 Install the blade. See "Installing a Blade" on page 148. 15 Assign a new system and/or setup password. See "System and Setup Password Features" on page 140. System Board Information 335