Dell PowerEdge M710HD Fabric OS Administrator’s Guide - Page 272

10 Setting up IP addresses for a Virtual Fabric 19 19 1e1300 -- N8 No_Module FC 20 20 1e1400 -- N8 No_Module FC switch_25:FID7:admin> configure Not all options will be available on an enabled switch. To disable the switch, use the "switchDisable" command. Configure... Fabric parameters (yes, y, no, n): [no] y WWN Based persistent PID (yes, y, no, n): [no] Allow XISL Use (yes, y, no, n): [yes] n WARNING!! Disabling this parameter will cause removal of LISLs to other logical switches. Do you want to continue? (yes, y, no, n): [no] y System services (yes, y, no, n): [no] switch_25:FID7:admin> lscfg --change 7 -base Creation of a base switch requires that the proposed new base switch on this system be disabled. Would you like to continue [y/n]?: y Disabling the proposed new base switch... Disabling switch fid 7 Please enable your switches when ready. switch_25:FID7:admin> switchenable Setting up IP addresses for a Virtual Fabric NOTE IPv6 is not supported when setting the IPFC interface for Virtual Fabrics. 1. Connect to the switch and log in using an account assigned to the admin role. 2. Enter the ipAddrSet -ls command. 3. Enter the network information in dotted-decimal notation for the Ethernet IPv4 address with a CIDR prefix. Example of setting an IP address for a logical switch in a Virtual Fabric with an FID of 123 in non-interactive mode with the CIDR prefix: switch:admin> ipaddrset -ls 123 --add 11.1.2.4/24 Removing an IP address for a Virtual Fabric 1. Connect to the switch and log in using an account assigned to the admin role. 2. Enter the ipAddrSet -ls FID - -delete command. switch:admin> ipaddrset -ls 123 -delete Configuring a logical switch to use XISLs When you create a logical switch, by default it is configured to use XISLs. Use the following procedure to allow or disallow the logical switch to use XISLs in the base fabric. 232 Fabric OS Administrator's Guide 53-1001763-02