Dell PowerEdge M710HD Fabric OS Administrator’s Guide - Page 513

FC Router port cost configuration 21 EX_Ports and VEX_Ports, when connected, are assigned different router port costs and traffic will flow only through the EX_Ports. Routing failover is automatic, but it can result in frames arriving out of order when frames take different routes. The FC router can force in-order delivery, although frame delivery is delayed immediately after the path failover. Source EX_Ports can balance loads across multiple destination EX_Ports attached to the same edge fabric using exchange IDs from the routed frames as keys to distribute the traffic. Setting router port cost for an EX_Port The router port cost value for an EX_Port is set automatically when the EX_Port is created. However, you can modify the cost for that port. You can configure the EX_ or VEX_Port with values of either 1000 or 10,000. If you want to differentiate between two EX_Port links with different speeds, you can assign 1000 to one link and 10,000 to the other link. For details about the use of any of the following commands, see the Fabric OS Command Reference. 1. Enter the portDisable command to disable any port on which you want to set the router port cost. switch:admin> portdisable 7/10 2. Enable EX_Port or VEX_Port mode with the portCfgEXPort or portCfgVEXPort command. switch:admin> portcfgexport 7/10 -a 1 3. Enter the fcrRouterPortCost command to display the router port cost for each EX_Port. switch:admin> fcrrouterportcost Port Cost 7/3 1000 7/4 1000 7/9 1000 7/10 1000 7/13 1000 10/0 1000 You can also use the fcrRouteShow command to display the router port cost. 4. Enter the fcrRouterPortCost command with a port and slot number, to display the router port cost for a single EX_Port. switch:admin> fcrrouterportcost 7/10 Port Cost 7/10 1000 5. Enter the appropriate form of the fcrRouterPortCost command based on the task you want to perform: • To set the router port cost for a single EX_Port, enter the command with a port and slot number and a specific cost: switch:admin> fcrrouterportcost 7/10 10000 • To set the cost of the EX_Port back to the default, enter a cost value of 0: switch:admin> fcrrouterportcost 7/10 0 6. Enter the portEnable command to enable the ports that you disabled in step 1. switch:admin> portenable 7/10 Fabric OS Administrator's Guide 473 53-1001763-02