Dell PowerEdge T420 Owner's Manual - Page 120
iDRAC7 User's Guide, If applicable, place the system upright on a flat
View all Dell PowerEdge T420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
1. Unpack the new system board assembly. CAUTION: Do not lift the system board assembly by grasping a memory module, processor, or other components. 2. Hold the touch points and lower the system board into the chassis ensuring that the guiding slot on the system board is aligned with the tab on the chassis. NOTE: The guiding slot on the system board is located on the edge of the system board and near the memory modules. 3. Push the system board toward the back of the chassis until the system board clicks into place. 4. Use the 11 screws to secure the system board to the chassis. NOTE: Secure the screws along the edges of the system board first, and follow a diagonal path to complete this procedure. 5. Install the following as applicable: a) heat sink and processor b) memory modules c) internal dual SD module d) internal USB key e) expansion-cards f) iDRAC ports card g) PCIe card holder h) system cooling fan i) cooling shroud 6. Reconnect all cables to the system board. 7. Close the system. 8. If applicable, place the system upright on a flat, stable surface and rotate the system feet outward. 9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals. 10. Import your new or existing iDRAC Enterprise license. For more information, see iDRAC7 User's Guide, at support.dell.com/manuals. 120