Dell PowerEdge XL 5133-4 Dell PowerEdge M I/O Aggregator Getting Started Guide - Page 34
Next Steps
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Next Steps • You can customize the Aggregator for use in your data center network as necessary. To perform additional switch configuration, do one of the following: • For remote out-of-band management, enter the OOB management interface IP address into a Telnet or SSH client and log in to the switch using the user ID and password to access the CLI. • For local management using the CLI, use the attached console connection. • For remote in-band management from a network management station, enter the VLAN IP address of the management port and log in to the switch to access the CLI. • If you installed the Aggregator in a stack, you can configure additional settings for switch stacking. • In case of an FTOS upgrade, you can check to see that an Aggregator is running the latest FTOS version by entering the show version command. To download an FTOS version, go to http://support.dell.com. For information about how to configure software features, refer to the User's Configuration Guide for the PowerEdge M I/O Aggregator on the Dell Support website at http://support.dell.com/manuals. 34 Next Steps