Dell PowerVault 35F Dell PowerVault 35F Fibre Channel Bridge Rack Installation - Page 10
Qvwdoolqj²wkh²2xwhu²6olghv
View all Dell PowerVault 35F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
3. Align the holes of the inner-slide rails with the holes on the side of the bridge (see Figure 1-3). You must press the manifold and bridge together, compressing the gasket, to get the holes in the inner-slide rails and bridge to align. inner-slide rail bezel manifold inner-slide rail bridge 6-32 x 1/4-inch screws (4) )LJXUH0RXQWLQJWKH%ULGJHWRWKH0DQLIROG 4. Use four 6-32 x 1/4-inch screws to mount the inner-slide rails to the bridge. ,QVWDOOLQJWKH2XWHU6OLGHV To install the outer slide in the rack, perform the following steps: 1. Align the holes of the stationary and adjustable brackets with the holes in the rack. The stationary brackets attach to the front of the rack. The adjustable brackets attach to the rear. The top hole of each bracket must align with top hole of an Electronic Industry Association (EIA) unit in the rack. The top hole of an EIA unit has a dot next to it (see Figure 1-4). NOTE: The slides must be mounted within 1 EIA unit. The height of the bridge takes up 1 EIA unit. 1-6 Dell PowerVault 35F Fibre Channel Bridge Rack Installation Guide