Dell PowerVault DL2200 CommVault Hardware Owner's Manual - Page 30
in BIOS. The BIOS setting, USB cables and SAS/SATA
View all Dell PowerVault DL2200 CommVault manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Message Causes Corrective Actions Read fault Requested sector not found. The operating system cannot Replace the USB medium read from the hard drive or and device. Ensure that the USB device, the system could USB cables and SAS/SATA not find a particular sector on backplane cables are properly the disk, or the requested connected. sector is defective. See "Troubleshooting a USB Device" on page 130 or "Troubleshooting a Hard Drive" on page 139 for the appropriate drive(s) installed in your system. SATA Port x device not found. There is no device connected Information only. to the specified SATA port. Sector not found. Faulty hard drive, USB Seek error. device, or USB medium. Seek operation failed. Replace the USB medium or device. Ensure that the USB or SAS backplane cables are properly connected. See "Troubleshooting a USB Device" on page 130 or "Troubleshooting a Hard Drive" on page 139 for the appropriate drive(s) installed in your system. Shutdown failure. General system error. See "Getting Help" on page 157. Sparing mode disabled. For sparing mode, matched sets of three must be populated across slots. The memory configuration does not match the setting in BIOS. The BIOS setting has been disabled. Reconfigure the memory modules for Memory Sparing mode. See "System Memory" on page 80. 30 About Your System