Dell PowerVault DL2200 Hardware Owner's Manual - Page 33
Lifecycle Controller User, Guide, Integrated, Dell™ Remote, Access Controller 6, iDRAC6 User Guide
View all Dell PowerVault DL2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Message Causes Corrective Actions Unable to launch System Services image. System halted! System halted after F10 Restart the system and keystroke because System update the Lifecycle Services image is either Controller repository to the corrupted in the system latest software to restore full firmware or has been lost due functionality. See the to system board replacement. Lifecycle Controller User The optional iDRAC6 Guide for more information. Enterprise card flash memory Restore the flash memory or BMC SPI flash may be using the latest version on corrupted. support.dell.com. See the Integrated Dell™ Remote Access Controller 6 (iDRAC6) User Guide for instructions on performing a field replacement of the flash memory. Unexpected interrupt in protected mode. Improperly seated memory modules or faulty keyboard/mouse controller chip. Reseat the memory modules. See "Troubleshooting System Memory" on page 137. If the problem persists, see "Getting Help" on page 157. Unsupported CPU combination Unsupported CPU stepping detected. Processor(s) is not supported Install a supported processor by the system. or processor combination. See "Processors" on page 103. Unsupported DIMM detected. The following DIMM has been disabled: x Invalid memory configuration. The system runs but with the specified memory module disabled. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 81. About Your System 33