Dell PowerVault MD3000i Dell PowerVault MD3000/MD3000i RAID Controller Pass
Dell PowerVault MD3000i Manual
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell PowerVault MD3000i manual content summary:
- Dell PowerVault MD3000i | Dell PowerVault MD3000/MD3000i RAID Controller
Pass - Page 1
Dell™ PowerVault™ MD3000/MD3000i RAID Controller Password Reset Perform this procedure when you have lost or forgotten your password and you need to reset it. Connecting the Serial Cable 1 Remove the serial cable from the password reset cable package. 2 Connect the DB9 (oval) end of the cable to the - Dell PowerVault MD3000i | Dell PowerVault MD3000/MD3000i RAID Controller
Pass - Page 2
to open the configuration screen. 4 Select Serial Port Setup and press . 5 Press to change Hardware Flow Control setting to no. setup screen. Reset Password The procedure you should use to reset the password depends on whether your RAID controller is running first-generation firmware - Dell PowerVault MD3000i | Dell PowerVault MD3000/MD3000i RAID Controller
Pass - Page 3
password reset cable. 10 To set a new password, go to the Modular Disk Storage Manager software under the Tools tab and click Set Or Change Password Link. 11 Leave the Current Password blank, enter the new password twice, and click OK. RAID Controllers Using Second-Generation Firmware (Version - Dell PowerVault MD3000i | Dell PowerVault MD3000/MD3000i RAID Controller
Pass - Page 4
, press and . 6 When prompted if you want to reset your storage array password, press and . 7 Close HyperTerminal or MINICOM. 8 Remove password reset cable. 9 To set a new password, go to the Modular Disk Storage Manager software under the Tools tab and click Set Or Change
Dell™ PowerVault™
MD3000/MD3000i RAID Controller
Password Reset
Perform this procedure when you have lost or forgotten your password and you
need to reset it.
Connecting the Serial Cable
1
Remove the serial cable from the password reset cable package.
2
Connect the DB9 (oval) end of the cable to the serial port on the computer to
be used to communicate with the RAID Controller module.
3
Connect the PS2-type (round) end of the cable to the serial port on either of
the array’s RAID Controller Modules. The flat side of the connector faces
down when inserting.
System Setup
Microsoft
®
Windows
®
Operating Systems
1
Click
Start
→
Programs
→
Accessories
→
Communication
→
HyperTerminal
to
run HyperTerminal.
If HyperTerminal is not installed, click
Control Panel
→
Add/Remove
Programs
→
Add/Remove Windows Components
, find
HyperTerminal
and
click the check-box, then click
Apply
and
OK
.
NOTE:
The original Windows installation disk may be needed to install
HyperTerminal.
NOTE:
If you are running Windows Vista
®
or Windows Server
®
2008,
HyperTerminal is not included in the operating system. To complete these steps, a
third-party terminal emulation program is required.
March 2009