Dell PowerVault Storage Area Network Owner's Manual - Page 115
events are not captured., Some management software do not report
View all Dell PowerVault Storage Area Network manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Error Code SEL0006 SEL0008 SEL0012 SEL1204 TMP0118 TMP0119 Message Information Details Action The chassis was opened while the power was off. System security may have been compromised. Close the chassis and verify hardware inventory. Check system logs. Message Details Action All event logging is disabled. This message is displayed when all event logging has been disabled by the user. If unintended, re-enable logging. Message Details Action Log is full. When the event log is full, additional events are not written to the log. Older events may be overwritten and lost. This message may also appear if the user disabled event logging. Backup and clear log. Message Details Action Could not create or initialize the system event log. If the system event log fails to initialize, platform status and failure events are not captured. Some management software do not report platform exceptions. Reboot the management controller or iDRAC. Cycle system input power. If problem persists call support. Message Details Action An unknown system hardware failure detected. If the system event log failed to initialize, platform status and failure events are not captured. Some management software do not report platform exceptions. Re-configure system to the minimum supported configuration. If issues persists, contact support. Message Details Action The system inlet temperature is less than the lower warning threshold. Ambient air temperature is too cool. Check the system operating environment. Message Details The system inlet temperature is less than the lower critical threshold. Ambient air temperature is too cool. 115