Dell PowerVault TL4000 Dell PowerVault TL4000 Failover Configuration Guide - Page 19
Please follow the steps under Backup Application Setup and Support for Configuring Dual Host
 |
View all Dell PowerVault TL4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Dell PowerVault™ TL4000/TL2000 Failover Guide Note: Please follow the steps under Backup Application Setup and Support for Configuring Dual Host Bus Adapters even if your library configuration contains SAS drives or Fibre Channel direct attached drives. The configuration settings under Configuring Dual Host Bus Adapters will allow your SAS or direct attached Fibre Channel configuration to support failover. Once CommVault is installed, there are additional steps to configure failover. Access the CommVault failover configuration instructions at http://www.commvault.com/. • Navigate to the Services tab • Select Support Services then Documentation • Select the Books Online link for your software version • Select the search option located in the upper right side of the page • Search for keywords "SAN‐Attached Libraries" • Locate the article named "SAN‐Attached Libraries" and follow the instructions provided for "Configuring Dual Host Bus Adapters (HBA)" Once CommVault is correctly configured for failover, the screen shown in Figure 14 below is displayed. Figure 14: Fully configured CommVault Application 19 | P a g e 12/31/09 version 2.0 Always refer to www.dell.com\support for latest documentation and updates
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14 -
15 -
16 -
17 -
18 -
19 -
20 -
21 -
22
 |
 |
