Dell Precision M2800 Dell Owners Manual - Page 24

Removing the Network Connector, Before Working Inside Your Computer, battery, base cover

Get Dell Precision M2800 PDF manuals and user guides View all Dell Precision M2800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Removing the Network Connector 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove: a. battery b. base cover c. base-corner cover (left) 3. Perform the following steps as shown in the illustration: a. Disconnect the cable from the system board. b. Release cable from the routing channel. c. Remove the screw that secures the network-connector bracket to the computer. 4. Lift the network-connector bracket from the computer. Lift the network connector from the computer. Installing the Network Connector 1. Align the network connector to its position on the computer. 2. Place the network-connector bracket on the network connector. 3. Tighten the screw to secure the network-connector bracket to the computer. 4. Route the cable through the routing channel. 5. Connect the cable to the system board. 6. Install: a. base-corner cover (left) b. base cover c. battery 7. Follow the procedures in After Working Inside Your Computer. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
Removing the Network Connector
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a.
battery
b.
base cover
c.
base-corner cover
(left)
3.
Perform the following steps as shown in the illustration:
a.
Disconnect the cable from the system board.
b.
Release cable from the routing channel.
c.
Remove the screw that secures the network-connector bracket to the computer.
4.
Lift the network-connector bracket from the computer. Lift the network connector from the
computer.
Installing the Network Connector
1.
Align the network connector to its position on the computer.
2.
Place the network-connector bracket on the network connector.
3.
Tighten the screw to secure the network-connector bracket to the computer.
4.
Route the cable through the routing channel.
5.
Connect the cable to the system board.
6.
Install:
a.
base-corner cover
(left)
b.
base cover
c.
battery
7.
Follow the procedures in
After Working Inside Your Computer
.
24