Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.4 - Page 1042

Usage Information You can configure an arbitrary value in the IP address format for each router. However, each router ID must be unique. If you use this command on an OSPF router process, which is already active (that is, has neighbors), a prompt reminding you that changing the router-id brings down the existing OSPF adjacency. The new router ID is effective at the next reload. Example DellEMC(conf)# router ospf 100 DellEMC(conf-router_ospf)#router-id 1.1.1.1 Changing router-id will bring down existing OSPF adjacency [y/n]: DellEMC(conf-router_ospf)#show config ! router ospf 100 router-id 1.1.1.1 DellEMC(conf-router_ospf)# no router-id Changing router-id will bring down existing OSPF adjacency [y/n]: DellEMC# router ospf To configure an OSPF instance, enter ROUTER OSPF mode. Syntax router ospf process-id [vrf {vrf name}] To clear an OSPF instance, use the no router ospf process-id command. Parameters process-id vrf name Enter a number for the OSPF instance. The range is from 1 to 65535. (Optional) Enter the VRF process identifier to tie the OSPF instance to the VRF. All network commands under this OSPF instance are then tied to the VRF instance. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.10(0.1) 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 9.1(0.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.9.1.0 7.8.1.0 7.6.1.0 Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. Introduced on the S6100-ON. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Added support for OSPFv3 on the S4810 and Z9000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for VRF. Added support for Multi-Process OSPF. Introduced on the S-Series. 1042 Open Shortest Path First (OSPFv2 and OSPFv3)