Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.4 - Page 1579

Version 8.3.11.1 8.3.7.0 8.2.1.0 7.8.1.0 7.7.1.0 7.6.1.0 E-Series original Command Description Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. C-Series and S-Series accept both bytes of the 2-byte S-Tag TPID. Functionality augmented for C-Series and S-Series to enable multi-purpose use of the port. Functionality augmented for E-Series to enable multi-purpose use of the port. Introduced on the C-Series and S-Series. Usage Information Prior to using this command, to place the interface in Layer 2 mode, use the switchport command. To remove the trunk port designation, first remove the port (using the no member interface command) from all stackable VLAN-enabled VLANs. In Example 1, a VLAN-Stack trunk port is configured and then made part of a single-tagged VLAN. In Example 2, the tag protocol identifier (TPID) is set to 88A8. The Gi 3/10 port is configured to act as a VLANStack access port; the Gi 5/1 port acts as a VLAN-Stack trunk port, switching stackable VLAN traffic for VLAN 10, while also switching untagged traffic for VLAN 30 and tagged traffic for VLAN 40. (To allow VLAN 30 traffic, you need the native VLAN feature. Use the portmode hybrid command. For more information, see the portmode hybrid command. Example 1 DellEMC(conf-if-gi-1/42)# switchport DellEMC(conf-if-gi-1/42)# vlan-stack trunk DellEMC(conf-if-gi-1/42)# show config ! interface GigabitEthernet 1/42 no ip address switchport vlan-stack trunk no shutdown DellEMC(conf-if-gi-1/42)# interface vlan 100 DellEMC(conf-if-vl-100)# vlan-stack compatible DellEMC(conf-if-vl-100-stack)# member gigabitethernet 1/42 DellEMC(conf-if-vl-100-stack)# show config ! interface Vlan 100 no ip address vlan-stack compatible member GigabitEthernet 1/42 shutdown DellEMC(conf-if-vl-100-stack)# interface vlan 20 DellEMC(conf-if-vl-20)# tagged gigabitethernet 1/42 DellEMC(conf-if-vl-20)# show config ! interface Vlan 20 no ip address tagged GigabitEthernet 1/42 shutdown DellEMC(conf-if-vl-20)# do show vlan Codes: * - Default VLAN, G - GVRP VLANs Q: U - Untagged, T - Tagged x - Dot1x untagged, X - Dot1x tagged G - GVRP tagged, M - Vlan-stack NUM Status Description * 1 Inactive 20 Active 100 Active DellEMC(conf-if-vl-20)# Q Ports T Gi 1/42 M Gi 1/42 VLAN Stacking 1579