Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.4 - Page 68

CAUTION: There is no undo for this command. Following are the factory-default environment variables: • baudrate • primary_boot • secondary_boot • default_boot • ipaddr • gatewayip • netmask • macaddr • mgmtautoneg • mgmtspeed100 • mgmtfullduplex Each boot path variable (primary_boot, secondary_boot, and default_boot) is further split into the following three independent variables: • primary_server, primary_file, and primary_type • secondary_server, secondary_file, and secondary_type • default_server, default_file, and default_type NOTE: For information on the default values that these variables take, refer to the Restoring Factory Default Environment Variables section in the Dell EMC Networking OS Configuration guide. Example (all stack units) DellEMC# restore factory-defaults stack-unit all clear-all * Warning - Restoring factory defaults will delete the existing * * startup-config and all persistent settings (stacking, fanout, etc.)* * All the units in the stack will be split into standalone units. * * After restoration the unit(s) will be powercycled immediately. * * Proceed with caution ! * Proceed with factory settings? Confirm [yes/no]:yes -- Restore status -- Unit Nvram Config 1 Success Success 2 Success Success 3 Success Success 4 Not present 5 Not present Power-cycling the unit(s). DellEMC# Example (single stack) DellEMC# restore factory-defaults stack-unit 1 clear-all Warning - Restoring factory defaults will delete the existing * * startup-config and all persistent settings (stacking, fanout, etc.)* * After restoration the unit(s) will be powercycled immediately. * * Proceed with caution Proceed with factory settings? Confirm [yes/no]:yes -- Restore status -Unit Nvram Config 1 Success Success Power-cycling the unit(s). DellEMC# Example (NvRAM all stack units) DellEMC# restore factory-defaults stack-unit all nvram 68 File Management