Dell S3845cdn Color Smart Multifunction Printer - CACStar Installation Guide - Page 47

Step 2: Disable Sleep Mode, Tap DC131 NVM Read/Write.

Get Dell S3845cdn PDF manuals and user guides View all Dell S3845cdn manuals
Add to My Manuals
Save this manual to your list of manuals

Page 47 highlights

Step 2: Disable Sleep Mode It is necessary to disable printer sleep mode for operation with CAC control. To do this, follow the following procedure (refer to the diagram of the operator panel below): 1. Turn the printer on. If the printer is already turned on but is in Power Save mode (the touchscreen will be dark), wake up the printer by pressing the power button in the lowerright corner of the operator panel. 2. Hold down the Home button for 5 seconds, then release it. You will be prompted for a passcode. 3. Enter "2456" and then tap the OK button. You will then see the Home screen with the word "Service" shown in the top left corner of the touchscreen. 4. Tap the "Diagnostics" tile. 5. Tap "DC131 NVM Read/Write". 6. Enter "700131" on the touchscreen (the "Chain-Link" section of the touchscreen will show "700-131"). Then tap the "Change" button. S3845cdn CACStar User Guide Rev A01 Copyright 2017 Digital Imaging Technology Page 47

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
S3845cdn CACStar User Guide Rev A01
Copyright 2017 Digital Imaging Technology
Page 47
Step 2: Disable Sleep Mode
It is necessary to disable printer sleep mode for operation with CAC
control.
To do this, follow the following procedure (refer to the
diagram of the operator panel below):
1.
Turn the printer on.
If the printer is already turned on but is
in Power Save mode (the touchscreen will be dark), wake up
the printer by pressing the power button
in the lower-
right corner of the operator panel.
2.
Hold down the Home button
for 5 seconds, then release
it. You will be prompted for a passcode.
3.
Enter “2456” and then tap the OK button.
You will then see
the Home screen with the word “Service” shown in the top
left corner of the touchscreen.
4.
Tap the “Diagnostics” tile.
5.
Tap “DC131 NVM Read/Write”.
6.
Enter “700131” on the touchscreen (the “Chain-Link” section
of the touchscreen will show “700-131”).
Then tap the
“Change” button.