Dell S3845cdn Color Smart Multifunction Printer - CACStar Installation Guide - Page 49

Note: If the FIPS 140-2 setting is turned on, this step will

Get Dell S3845cdn PDF manuals and user guides View all Dell S3845cdn manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

5. Click the [Install] button. Note: If the "FIPS 140-2" setting is turned on, this step will fail with an error message indicating that the clone file installation cannot be done with FIPS 140-2 enabled. In this case, turn off the FIPS 140-2 setting (in the [System]>[Security] section of the printer management web site) before installing the clone file. 6. After the cloning file is installed, the printer will restart automatically. 7. After the printer reboots, bring up the printer web site again, and make sure that DHCP is enabled, and the "Release IP on reboot" setting is also enabled. 8. If the CACStar hardware has not been installed yet, then turn the printer off, and install the CACStar hardware as described below. S3845cdn CACStar User Guide Rev A01 Copyright 2017 Digital Imaging Technology Page 49

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
S3845cdn CACStar User Guide Rev A01
Copyright 2017 Digital Imaging Technology
Page 49
5.
Click the [Install] button.
Note: If the “FIPS 140-2” setting is turned on, this step will
fail with an error message indicating that the clone file
installation cannot be done with FIPS 140-2 enabled.
In this
case, turn off the FIPS 140-2 setting (in the [System]-
>[Security] section of the printer management web site)
before installing the clone file.
6.
After the cloning file is installed, the printer will restart
automatically.
7.
After the printer reboots, bring up the printer web site again,
and make sure that DHCP is enabled, and the “Release IP on
reboot” setting is also enabled.
8.
If the CACStar hardware has not been installed yet, then turn
the printer off, and install the CACStar hardware as
described below.